The Voopoo Drag S Pro is a welcome update to the original Drag S kit.
What To Expect From The Voopoo Drag S Pro…
As this is an update it seems only right and proper to have a look at what the main differences are between the new and old versions.
The first main difference is the included tank – this time you have the TPP X Pod which is compatible with the TPP range of coils.
The TPP-DM1 0.15ohm coil and TPP-DM4 0.3ohm Mesh coil are both included in the kit.
If you purchase the PnP compatible pod you also have access to the large range of PnP coils too.
The TPP X Pod has a new top fill method involving pressing a button and rotating the top cap which should make it pretty childproof.
Looking at the Drag S Pro mod now – the battery capacity has been increased to 3000mAh and still has a USB Type C port for charging at an increased 2.5A charge rate.
The output has also been increased to 80W maximum and you have 3 user modes to choose from – RBA mode (full Variable Wattage control), Smart Mode (device sets the output automatically to suit the installed coil) and Temperature Control (need to download firmware update to enter TC mode).
The GENE.TT chip found in the original has now been replaced with the new GENE.Fan 3.0 chip which can boost the output up to 8.5V.
Also the adjustable airflow has been improved to give a wider range of adjustment.
A new feature is the manual On/Off switch similar to that introduced again recently in the Geekvape L200 to help prevent accidental firing.
If using the included tank you can fire the device using a manual fire button press or there is also an air sensor for inhale activation.
There are 7 colours to choose from: Mystic Red, Classic Black, Basalt Grey, California Orange, Garda Blue, Sapphire Blue, and Sahara Brown.
- Voopoo Drag S Pro device
- TPP X Pod
- DM1 TPP 0.15ohm coil
- DM4 TPP 0.3ohm coil
- USB Type C cable
- User manual
Voopoo Drag S Pro Mod Specs
- Size: 125x28x34mm (including tank)
- Battery: 3000mAh (internal)
- Display: Colour screen – size not specified
- Output: 5-80W (0-8.5V)
- User modes: VW (RBA Mode) , Smart (Auto wattage), TC (enabled by firmware update)
- Type C USB charging – 2.5A charge rate
- Resistance range: 0.1-3ohm
- Manual on / off switch
- GENE.FAN 3.0 chipset
- Auto / Manual fire modes
Voopoo TPP X Pod Specs
- Size: Not specified
- Capacity: 5.5ml (standard) / 2ml (TPD)
- Coil: TPP coil range, purchase PnP pod for use with PnP coils
- Adjustable airflow
- 510 base included
- 810 drip tip
- Top fill port
Some of the earlier Drag pod kits suffered from low output due to the low voltage – so I am pleased to see a voltage boost in the new chipset.
Let me know your thoughts on the Voopoo Drag S Pro in the comments below!