The Vapefly Alberich II MTL RTA is an update to the original.
What To Expect From The Vapefly Alberich II MTL RTA…
This is a RTA (Rebuildable Tank Atomiser) and the MTL in the title refers to “Mouth To Lung” which is a vaping style preferred often by ex-smokers due to the ability to have a restricted airflow and higher nicotine strengths.
As mentioned above this version is an update to the original Alberich MTL RTA and improvements have been made in capacity and airflow design.
The basics are that this is for single coil builds and you get 2x 1ohm coils in the kit and even Firebolt Cotton to get you started.
Incoming airflow enters in the top of the atomiser, which helps prevent leaking. Bottom airflow atomisers can often have e-liquid seeping out of the airflow inlets.
The airflow then travels down to the deck through the airflow pin to the coil.
There are 6 airflow pins included in the kit and each has a different diameter air hole, so you can replace the pin to reduce or increase the airflow to suit your preference. You can even change the airflow pin without removing the coil.
A quarter turn screw off top cap gives access to the fill port.
This has a 4ml capacity, I have not seen a 2ml version for TPD regulated areas mentioned as yet.
Here is a brief introduction video from the Vapefly_Official YouTube channel.
There are 3 colours to choose from: Silver, Black and Gunmetal.
- Vapefly Alberich II MTL RTA
- 4ml glass
- 1ohm KA1 pre-built coil
- 1ohm Ni80 pre-built coil
- 2x Firebolt Cotton
- 6x airflow pins
- 4x screws
- User manual
Vapefly Alberich II MTL RTA Specs
- Size: 23×59.6mm
- Capacity: 4ml
- Single coil deck
- 510 drip tip
- Top airflow inlet
- Replaceable airflow outlet pins – 6 different diameter pins included in kit
- Can replace airflow pins without removing coil
- Top refill
The top airflow system should drastically help reduce chances of leaking so this looks to be a great upgrade.
Let me know what you think of the Vapefly Alberich II MTL RTA in the comments below!